Skip to main content

Made in Valdosta: Regal Marine - Building boats one detail at the time

September 28, 2014

Valdosta Daily Times: Sunday, September 28, 2014

Stuart Taylor

VALDOSTA — Regal Marine was started in 1968. As the company survived through numerous national recessions, it learned two important things: Debt is twice as problematic during a recession and the company that tend to weather recessions the best are those focused on high-quality production.

So, the company pulled itself out of debt and rededicated itself to quality.

When Bayliner decided to close down its Valdosta plant in 2001, Regal bought it and opened up in Valdosta.

“We picked up a ton of good people, and most of the people that started with us in 2001 are still with us,” said Greg Justice, director of manufacturing.

Since then, boats have become more specialized, much in the same way automobiles have.

“Boats have become much more complicated. As the marine industry has progressed, it's become more automotive-like with fit and finish, with upholstery, electronics, the features in the boat whether it's iPod docking or GPS, wake-boarding towers, different paint schemes.”

Here's the thing about boats: When you're standing in one — in the middle of a lake, out at sea, in your neighbor's back yard after they bring it home for the first time — it's easy to lose sight of all the intricate, detailed work that went into making it.

Or why not take the boat itself?

“Everything starts with the molding. If you think about boat building, it's like baking a cake, only you put the icing in the pan. We start with the mold and gel coat that.”

Striping is masked off and the painting process is started, taking up to seven different coats.

The first of which is called a skin coat, a very thin layer of fiberglass and resin that gets rolled and smoothed out after application to consolidate the fiberglass and get the air bubbles out of it.

Like any complicated, multi-step production process, any mistake made early on only compounds as it goes along.

As such, the men and women working on the initial layers have to keep a critical eye.

“There's an art to that. The people who work here do a better job at that than I've ever seen.”

After it cures, they come back and build the rest of the boat up.

To do that, they'll add another layer of fiberglass, followed by core material and another layer of fiberglass.

When it's ready, the hull is pulled out of the mold, flanges are taken off and holes are cut as needed.

After the cosmetic side of things is taken care of, boats move on to the assembly process, which starts at Open Hole 1.

There, trunk liners are installed along with electrical runs.

“The goal is to get as much assembly done as possible before the motor is put in.”

After the motor is installed comes the deck.

“We pick the deck up with a hoist, put the hull under it, and it's a shoebox fit.”

All the plumbing and electrical connections are made and it’s sent to final build where cabinets are installed along with upholstery, all of it made in house.

To test its water worthiness, boats go into a water tank where they're tested on the water under rain conditions.

“And then we'll pick a boat from time to time and we'll take it to the lake, run it and take about two days to go through it and look at it in detail.”

Windshields and a canvas top are put in, sometimes with carpet, too.

Final checklists are marked, i's are dotted, t's are crossed.

And what started out as resin in a tanker, gel coat in a drum, rolls of fabric and containers of paint heads out to the sea, the lake and your neighbor's back yard on the first day they bring it home.

 

 

Map icon
MAP ROOM

Handshake Icon
CONTACT US TODAY

Map Location icon
SITES AND BUILDINGS

© Copyright 2024 Valdosta-Lowndes County Economic Development.
All rights reserved. | Website developed by Marketing Alliance  Inc. | PRIVACY POLICY